EasyManua.ls Logo

THOMSON DPL950VD - Page 9

THOMSON DPL950VD
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ASMP1002
First issue 01 / 04 15
16
Note :
Power Supply primary circuit measurements.
- Use only (PRIMARY GND) connection point.
Attention :
Mesure dans la partie primaire de l'alimentation
- Utiliser la masse du bloc alimentation (PRIMARY GND).
Achtung :
Bei Messungen im Primärnetzteil
- Primärnetzteilmasse verwenden (PRIMARY GND).
TO AMPLI BOARD (N502)
TO MPEG BOARD (CON5)
308
5,8
1,1
2,4
327
5,8
15,5
0
0
0
0
11,2
10,1
0
0
1
1
350
1,1
5,8
13,5
5,8
4,2
3,2
367
0,6
5,8
0,6 5
4
108,2
108,9
4,6
4,3
11,4
2,4
2,4
9,7
1
1
11,2
4
0
2,5
5,8
5,8
4,9
3,3
Part of board connected to mains supply.
Partie du chassis relié e au secteur.
Primärseite des Netzteils.
Parte dello châssis collegata alla rete.
Parte del chasis conectada a la red.
Use isolating mains transformer
Utiliser un transformateur isolateur du secteur
Einen Trenntrafo verwenden
Utilizar un transformador aislador de red
Utilizzare un transformatore per isolarvi dalla rete
!
Attenzione :
misure nell'alimentatore primario
- usare massa alimentazione primario (PRIMARY GND).
Cuidado :
Medida en el bloque de alimentacion
- Utilizar la masa del bloque de alimentacion (PRIMARY GND).
Indicates critical safety components, and
identical components should be used for
replacement.
Only then can the operational safety be garanteed.
Le remplacement des éléments de sécurité
(repérés avec le symbole ) par des composants
non homologués selon la Norme CEI 65 entraine la
non-conformité
de l'appareil. Dans ce cas, la responsabilité du
fabricant n'est plus engagée.
!
!
!
!
Wenn Sicherheitsteile (mit dem Symbol
gekennzeichnet) durch nicht
normgerechte Teile ersetzt werden, erlischt die
Haftung des Herstellers.
La sostituzione degli elementi di sicurezza
(marcati con il segno )
con componenenti non omologati secondo la norma
CEI 65 comporta la non conformitá dell'apparecchio.
In tal caso é “esclusa la responsabilità” del costruttore.
La subtitución de elementos de seguridad
(marcados con el simbolo ) por componentes no
homologados segun la norma CEI 65, provoca la no
conformidad del aparato.
En ese caso, el fabricante cesa de ser responsable.
!
POWER SUPPLY SCHEMATIC DIAGRAM - SCHEMA DE L'ALIMENTATION - SCHALTBILD NETZTEIL - SCHEMA DELL' ALIMENTAZIONE - ESQUEMA DE LA ALIMENTACIÓN