4
CONNECTION
1. CONNECT THE POWER CORD (16) TO AC OUTLET
2. SWITCH ON THE UNIT BY POWER ON/OFF KNOB (8). IF THE POWER LED INDICATOR (9) IS ON
WITH RED LIGHT, IT MEANS THE POWER SUPPLY IS NORMAL. NOW YOUR SYSTEM IS READY
TO PLAY.
LISTENING TO RADIO
MANUAL TUNING
1. SWITCH TO TUNER (AM OR FM) POSITION BY FUNCTION SELECTOR (5).
2. TUNE TO THE REQUIRED STATION BY TURNING THE TUNING KNOB (4).
3. ADJUST VOLUME KNOB (8) TO THE DESIRED VOLUME LEVEL.
FM & FM-STEREO RECEPTION
THIS UNIT’S DEFAULT MODE IS FM STEREO MODE, IF STEREO PROGRAMS ARE RECEIVED. THE
“FM ST” LED INDICATOR (6) WILL LIGHT UP TO SHOW FM STEREO PROGRAM IS PLAYING.
HINTS FOR BEST RECEPTION:
- AM: THE UNIT HAS A BUILT-IN AM BAR ANTENNA. IF AM RECECPTION IS WEAK, SLIGHTLY
ROTATE OR RE-POSITIONING THE UNIT WILL USUALLY IMPROVE THE AM RECEPTION.
- FM: THE UNIT HAS A BUILT-IN FM WIRE ANTENNA (14) HANGING AT THE REAR CABINET. THIS
WIRE SHOULD BE TOTALLY UNRAVELED AND EXTENDED FOR BEST RECEPTION.
PHONO
NOTE:
- REMOVE THE STYLUS PROTECTOR.
- BE SURE THAT THE TONE ARM IS DETACHED FROM THE
TONE ARM REST BEFORE OPERATING AND RE-SECURED
AGAIN AFTERWARDS.
1. SELECT TO “PHONO” FUNCTION (5).
2. SET THE SPEED SELECTOR (11) TO THE PROPER POSITION
DEPENDING ON THE RECORD TO BE PLAYED.
3. PLACE THE RECORD ON THE PLATTER (USE THE SPINDLE ADAPTOR
(10) IF REQUIRED).
4. LIFT THE TONE ARM FROM THE REST AND SLOWLY MOVE IT TO THE
RECORD SIDE. THE PLATTER WILL START TO ROTATE.
5. PLACE THE TONE ARM TO THE DESIRED POSITION OF THE RECORD.
6. ADJUST THE VOLUME (8) TO THE DESIRED LEVEL.
7. AT THE END OF THE RECORD, THE PLATTER WILL AUTOMATICALLY STOP ROTATING. LIFT
THE TONE ARM FROM THE RECORD AND RETURN IT TO THE REST (12).
8. TO STOP MANUALLY, LIFT THE TONE ARM FROM THE RECORD AND RETURN IT TO THE REST
(12).
REMARK: AS SOME KIND OF RECORD THE AUTO-STOP AREA WAS OUT OF THE UNIT’S SETTING,
SO IT WILL STOP BEFORE FINISH OF THE LAST TRACK. IN THIS CASE, SELECT THE AUTO-STOP
SWITCH (15) TO “ OFF ” POSITION, THEN IT WILL RUN TO THE END OF THE RECORD BUT WILL
NOT STOP AUTOMATICALLY (TURN OFF THE UNIT BY POWER BUTTON (8) OR SWITCH BACK THE
AUTO-STOP SWITCH (15) TO “ ON “ POSITION TO STOP THE PLATTER ROTATE). THEN PUT BACK
THE TONE ARM TO THE REST POSITION.
LINE OUT CONNECTION
YOU CAN CONNECT THE SYSTEM TO YOUR WHOLE HI-FI SYSTEM BY CONNECTING THE LINE OUT SOCKET
(13) TO THE AUXILIARY INPUT SOCKET WITH A RCA CABLE (NOT INCLUDED).
REMARK: THE SOUND FROM THE ORIGINAL BUILT-IN SPEAKER WILL CONTINUE AFTER CONNECTING TO
ANOTHER AUDIO SYSTEM VIA LINE OUT SOCKET. TURN THE VOLUME TO MINIMUM IN ORDER TO CANCEL
OUT THE BUILT IN SPEAKERS.
To Next Page
Loading...
