Why won't my THOMSON TDW 1445 Dishwasher start?
Your THOMSON Dishwasher might not start due to several reasons: a blown fuse or tripped circuit breaker (replace the fuse or reset the breaker, and remove other appliances from the circuit), the power supply not being turned on (ensure the dishwasher is on, the door is closed, and the power cord is plugged in), or the door not being properly closed (close the door securely).
How to fix a THOMSON TDW 1445 Dishwasher that leaves dishes not clean?
If your THOMSON Dishwasher isn't cleaning dishes properly, it could be due to several factors: improper arrangement of dishes, selecting a gentle wash program (select the intensive program), insufficient or unsuitable detergent (use more or change the detergent), a clogged spray arm (rearrange items for free rotation), or dirty/incorrectly positioned filters (clean and position them correctly).
What to do if water is not pumped from THOMSON TDW 1445 Dishwasher?
If water isn't being pumped out of your THOMSON Dishwasher, check for a kink in the drain hose, a clogged filter, or a clogged kitchen sink. If the kitchen sink is clogged, consider consulting a plumber.
Why THOMSON TDW 1445 leaves dishes not quite dry?
If your THOMSON Dishwasher leaves dishes damp, consider these possibilities: improper loading, insufficient rinse aid (increase or refill the rinse aid), or selecting the wrong program (choose a program with a longer washing time).
How to get rid of suds in THOMSON Dishwasher?
If you see suds in your THOMSON Dishwasher, it's likely due to improper or old detergent (use only special dishwasher detergent). If suds occur, open the door to let them evaporate, then close it and start a wash program to drain the water. Repeat if needed. Spilled rinse aid can also cause this (always wipe up spills immediately).
How to reduce noise from a THOMSON TDW 1445?
If your THOMSON Dishwasher is making excessive noise, it's likely that dishes are rattling against each other or the spray arms are hitting the dishes. Rearrange the dishes.
How to prevent streaks on dishes from THOMSON Dishwasher?
Streaking and staining on dishes from your THOMSON Dishwasher can be fixed by adjusting the rinse aid dispenser setting to a higher level.
How to remove white film from THOMSON Dishwasher?
To remove the white film caused by hard water minerals from the inside of your THOMSON Dishwasher, use a damp sponge with dishwasher detergent and wear rubber gloves. Only use dishwasher detergent to avoid foaming.
Why are there rust stains on cutlery after using THOMSON Dishwasher?
Rust stains on cutlery after using your THOMSON Dishwasher can occur if the cutlery isn't corrosion resistant or if a program isn't run after adding dishwasher salt, allowing traces of salt into the wash cycle. Always run the rapid washing program after adding dishwasher salt, and ensure no crockery is in the dishwasher when adding salt.
How to clean stained tub interior of THOMSON Dishwasher?
If the tub interior of your THOMSON Dishwasher is stained, it's likely due to using detergent with colourant. Make sure the detergent does not contain any colourant.
Appliance for domestic use; children and those with reduced capabilities need supervision.
Covers power disconnection, wet conditions, door hazards, overloading, and child safety.
Details internal/external views, components, and control panel functions.
Verify voltage, grounding, water pressure, and connect inlet hose correctly.
Explains washing process, drain hose, and power supply requirements.
Prepare dishes, secure them, load openings down, avoid stacking, and identify non-safe items.
Arrange cutlery correctly and utilize the five adjustable rack positions.
Arrange items to ensure water can reach all surfaces for effective cleaning.
Guide to placing crockery, adjusting rack height, and folding cup shelves.
Procedure for filling salt container and understanding the refill indicator light.
Adjust salt consumption by selecting levels H1-H6 based on water hardness.
Rinse aid aids drying; dispensers are on the inner door.
Steps for adding rinse aid and adjusting the dispenser setting.
Procedure for opening the dispenser and adding detergent.
Details various programmes, including EN 50242 comparability information.
Covers checks, programme selection, delay timer, half load, and starting the cycle.
How to add items mid-cycle or change a running programme.
Activate by holding '1/2' and 'timer' buttons simultaneously to lock panel.
Unplug before cleaning; use damp cloth, avoid chemical solvents or strong detergents.
Instructions for cleaning the filter unit, door edges, and spray arms.
Steps to take if the dishwasher is exposed to freezing temperatures.
Covers dishwasher not starting, water not pumped, and related causes like power or blockages.
Addresses suds, stained interiors, rust on cutlery, and noise issues.
Covers poor cleaning, streaking, staining, and incomplete drying results.
Details meanings and possible causes for E1 (Longer inlet time) and E4 (Overflow) errors.
Details manufacturer, model, place settings, energy/water consumption, efficiency classes, noise, dimensions, power, and water pressure.
Explanation of efficiency ratings and notes on consumption measurement.
Note on ECO programme efficiency and compliance with European standards.
Diagram showing overall dimensions: width, depth, height, and door closed width.
Appliance for domestic use; children and those with reduced capabilities need supervision.
Covers power disconnection, wet conditions, door hazards, overloading, and child safety.
Details internal/external views, components, and control panel functions.
Verify voltage, grounding, water pressure, and connect inlet hose correctly.
Explains washing process, drain hose, and power supply requirements.
Prepare dishes, secure them, load openings down, avoid stacking, and identify non-safe items.
Arrange cutlery correctly and utilize the five adjustable rack positions.
Arrange items to ensure water can reach all surfaces for effective cleaning.
Guide to placing crockery, adjusting rack height, and folding cup shelves.
Procedure for filling salt container and understanding the refill indicator light.
Adjust salt consumption by selecting levels H1-H6 based on water hardness.
Rinse aid aids drying; dispensers are on the inner door.
Steps for adding rinse aid and adjusting the dispenser setting.
Procedure for opening the dispenser and adding detergent.
Details various programmes, including EN 50242 comparability information.
Covers checks, programme selection, delay timer, half load, and starting the cycle.
How to add items mid-cycle or change a running programme.
Activate by holding '1/2' and 'timer' buttons simultaneously to lock panel.
Unplug before cleaning; use damp cloth, avoid chemical solvents or strong detergents.
Instructions for cleaning the filter unit, door edges, and spray arms.
Steps to take if the dishwasher is exposed to freezing temperatures.
Covers dishwasher not starting, water not pumped, and related causes like power or blockages.
Addresses suds, stained interiors, rust on cutlery, and noise issues.
Covers poor cleaning, streaking, staining, and incomplete drying results.
Details meanings and possible causes for E1 (Longer inlet time) and E4 (Overflow) errors.
Details manufacturer, model, place settings, energy/water consumption, efficiency classes, noise, dimensions, power, and water pressure.
Explanation of efficiency ratings and notes on consumption measurement.
Note on ECO programme efficiency and compliance with European standards.
Diagram showing overall dimensions: width, depth, height, and door closed width.
General| Brand | THOMSON |
|---|---|
| Model | TDW 1445 |
| Category | Dishwasher |
| Language | English |
To Next Page
