PASSING THE STEAM BROOM ON THE GROUND
NOT
E: It is recommended that you vacuum the floors before mopping
them to remove dust and dirt particles.
• Check that the extension tube, mop head and microfiber cloth are
properly installed. See “ASSEMBLING THE MULTIFUNCTIONAL STEAM
BROOM” section
• To mop, make sure the extension tube is securely connected.
• Follow the General Instructions for Use to start using steam. See tips
Select Steam Setting to choose the correct steam intensity setting for
the surface you want to clean.
• Use a regular back and forth motion on the floor, pushing and pulling
the broom. Work backwards to prevent you from stepping on the
surface you just cleaned.
• The microfiber cloth is present to absorb the humidity generated
during the passage of the mop. However, depending on the type of
surface cleaned and the steam intensity setting used, residual
moisture may persist. If so, we recommend that you simply allow the
floor to air dry. You can use a fan to speed up the drying process.
•
NOTE: Set the steam control dial to the LOW setting to minimize the
amount of moisture left on the floor.
NOTE: To avoid warping or damage from heat and humidity, use the Multi-
Function Steam Mop on properly sealed surfaces.
The mop head is large, and it might be difficult to clean some types of
floors (such as ceramic tiles) with deep joints.
To clean the joints between tiles more properly, it is recommended to use
the multifunction steam mop in steam cleaning mode. See the Steam
Cleaning section for more information.
ASSEM
BLE THE MULTIFUNCTIONAL STEAM MOP
STEAM CLEANING
• Check that the desired cleaning accessories (jet nozzle, brush,
multifunction head with window squeegee) are properly installed.
• For generally easier cleaning, remove the extension tube so that
the steam mop can be used in hand-held mode.
• Follow the General Instructions for Use to start using steam. See tips
Select Steam Setting to choose the correct steam intensity setting
for the surface you want to clean.
EN-17
To Next Page
Loading...