18 E
AUDIBLE SIGNAL ELIMINATION
At the end of timed cook, beeps will sound. The audible signal
can be turned off if you prefer quiet operation.
To Turn Sound Off
1. Touch Setup/Help pad.
2. Touch Setup/Help pad again.
3. Touch Start /Add-A-Minute pad. The display shows
SOUND
OFF.
To Restore Sound
1. Touch Setup/Help pad.
2. Touch Setup/Help pad again.
3. Touch Start /Add-A-Minute pad. The display shows
SOUND
ON.
END OF COOKING REMINDER
At end of timed cooking, the microwave will signal every 10
seconds for the first minute, then every 3 minutes until Stop/
Clear pad is touched, up to one hour.
To Turn Reminder Off
1. Touch Setup/Help pad three times. The display shows
REMIND SIGNAL OFF? TOUCH START.
2. Touch Start /Add-A-Minute pad. The display shows
REMIND
SIGNAL OFF
.
To Turn Reminder Signal Back On
1. Touch Setup/Help pad three times. The display shows
REMIND SIGNAL ON? TOUCH START.
2. Touch Start /Add-A-Minute pad. The display shows
REMIND
SIGNAL ON
.
AUTO START
If you wish to program the Drawer Microwave to begin
cooking automatically at a designated time of day, follow this
procedure.
1. Touch Setup/Help pad 4 times. The display shows
AUTO
START TOUCH START.
2. Touch Start /Add-A-Minute pad.
3. Enter start time.
4. Touch Timer/Clock pad.
5. Touch the number keys to enter cooking time.
Touch Power Level pad repeatedly until the desired power
level is reached.
6. Touch Start /Add-A-Minute pad.
DEMONSTRATION MODE
To Select Demo Mode
1. Touch Setup/Help pad five times. The display shows
DEMO
ON? HOLD START 3 SEC.
2. Hold Start /Add-A-Minute pad for 3 seconds. The display
shows
DEMO ON.
To Cancel Demo Mode
1. Touch Setup/Help pad five times. The display shows
DEMO
OFF? TOUCH START.
2. Touch Start /Add-A-Minute pad. The display shows
DEMO
OFF.
NOTE:
• Drawer Microwave doesn’t heat in Demo Mode.
• Display counts down quickly.
TIMER
1. Touch Timer/Clock pad and number 1.
2. Enter time.
3. Touch Timer/Clock pad again.
To cancel timer, touch Stop/Clear.
STANDBY MODE
This microwave will go into standby mode after a period of
inactivity. The backlight of the display will automatically dim
after 3 minutes if the unit has not been in operation. If the
display is in standby mode, simply touch the control panel
or open/close the door to return the backlight to maximum
brightness.
SETTINGS
To Next Page
Loading...
