55
Controls and Operations
InWall Slide Out
Keep people and obstructions clear of room when operating.
Manual Override
In the event that the InWall Slide Unit fails to operate and manual operation is
necessary, proceed as follows:
1. Locate the control board.
2. Unplug both motors
3. The room may now be pushed in or out as desired. Larger rooms
may need several people to push. Try to keep both sides of the room
even. When the room is completely in, plug both motors back in to the
controller, this applies a brake to the motors and keeps the room locked
in position.
WINDOWS
TO AVOID EXHAUST GAS ENTRY INTO THE MOTOR
HOME, KEEP WINDOWS CLOSED WHEN THE CHASSIS
OR GENERATOR ENGINES ARE RUNNING.
All the windows that open in the motor home are operated by sliding them back and
forth. To operate, pivot the latch to release it from the locked position, and slide the
window to open. When closing, slide the window fully closed, and pivot the latch back
to the fully locked position. The screens will also slide open and closed if required for
an emergency exit.
Note: Check window sealant during normal washing and per
the Care And Maintenance section of this manual.
DO NOT MOVE THE MOTOR HOME UNLESS THE
MOTORS ARE PLUGGED IN.
If you are unable to move the room after following the
above procedure, then both motors will need to be
disengaged.
To Next Page
