THOR VL9000 - Electrical Connections; 3-Wire Cord Connections



be removed from the box after every drying cycle. If your
dryer is in the vicinity of a drain, you may allow the condensed
water to discharge directly into the drain through the drainpipe
provided.This eliminates the need to empty the box.
The method to connect the drainpipe is as follows:
1. Loosen the hose clip with the drain switchover joint;
2. Pull the hose off the joint;
3. Install the accessory drainpipe on the joint;
4. Fix the hose in place with the clip;
Note: The outlet of the drainpipe must not be higher than 3 feet above
the floor
Turning on power
Before turning on the power for the dryer, check:
Ƶ
Whether the supply voltage is in accordance with the value indicated on the
nameplate;
ƵW
hether the supply receptacle can withstand the maximum power load to
the dryer;
ƵWhether the electrical outlet is in accordance with the plug of the dryer.
If not, replace the power supply cable or outlet to make them accord
with each other; The replacement of the power supply cable must be
made by a qualified professional or our authorized service agent;
ƵThe dryer must be grounded securely.
Ƶ
Ƶ
Attention
ƵBefore use, clean any deposits from inside the drum of the dryer with
a wet towel;
Ƶ Clean debris on the filter screen to increase the drying efficiency.
Warning: Do not dry wool, silk, down and other delicate fabrics to avoid
damage to fabrics.
Load to dry
Make sure that the laundry you are going to dry is suitable for drying in a
dryer.You will find information on this on the laundry labels.The following
symbols mean:
Drain switchover
During the drying of the laundry, the condensate water is automatically
collected in a box inside the machine. The water needs to
A
B
Installation
Preparation
Treatment of laundry to dry
Ƶ
Check whether the laundry to be dried is suitable to be dried in the dryer;
ƵThe dryer can only dry the laundry that has been spun dry. Do not put too
wet laundry into the machine;
ƵEmpty all pockets of the laundry with such items as keys and coins and
remove the adornment that is not suitable to be dried;
ƵPull up zippers, sew and mend up loosened fasteners and tie up
dispersed ribbons to prevent the laundry from being entangled. If
necessary, put small items into a net.
Ƶ
To achieve a better drying result, shake the heavy laundry and make it loose
before load it into the dryer.
Dry at normal
temperature
Dry at
reduced temperature
Drying in the
tumble dryer
not possible