EasyManua.ls Logo

Thorn Champion User Manual

Thorn Champion
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
7
96261073 P- 10/2012
2,5 Nm
1
2
3
MHN - LA 2000
MHN - SB 2000
MHN - SB 2000 HO
1, 2, 3 2
MHN - LA 10001, 2, 3 2
MHN - FC 20001, 2, 3 2
MHN - FC 10001, 2, 3 2
HQI - TSS 2000 HF1, 2, 3 2
HQI - T 10001, 2, 3 2
HPI - T 10001, 2, 3 2
1, 2, 3 2
1, 2, 3 2
2
2
2
2
1, 2, 3
1, 2, 3
1, 2, 3
1, 2, 3
HQI - TSS 1000
HQI - TSL 2000
HQI - TSS 2000
HST - 1000
3
2
1
1
CHAMPION
TYPE : CHAMPION
96261073 PD 10/2012
Montážní návod
CZ
Istuzioni di monttaggio
IT
Szerelési útmutató
HU
Notice de montage
FR
Asennusohje
FI
Paigaldusjuhend
EE
Monteringsvejledning
DK
Montageanleitung
DE
Montavimo Instrukcijos
LT
Installation instructions
UK
Installationsanvisning
SE
RU
Instrukcja montazu
PL
Monteringsanvisning
NO
Instalacijas instrukcija
LV
IK08
IP66
T25
CLASS I
CLASS II
19 kg
18,5 kg
0,19 m
2
MINI
SC
x
MAX
17
2,5
2 m
455
635
MHN - FC
65°
55°
123
123
123
60°
675
MHTS - XL 2000
-Remplacer toute protection fissurée.
-Les luminaires classe II doivent être
installés de façon à ce que la partie
métallique ne soit pas en contact avec
l'installation électrique connectée à la terre.
A
TTENTION:Les luminaires classe I
doivent être reliés à la terre.
-Ce luminaire fonctionne à une tension
nominale qui doit être coupée avant
toute intervention sur l'appareillage.
-Toute modification de cet appareil est interdite.
-Respecter la distance minimale par rapport
aux objets éclairés définie par ce sigle.
-Ersätta alla spräckta skyddsplåtar.
-Klass II armaturer måste installeras så
att nakna metalldelar i armaturen inte
är i kontakt med någon elektrisk
installation,kopplad till en skyddledare.
VARNING
:Klass I armaturer måste vara
jordade.
-Denna armatur fungerar med högspänning
som måste vara frånslagen fore ingripande
i driftdonen.
-Alla ändringar i denna armatur är förbjuden.
-Sostituire sempre tutte le protezioni
danneggiate.
-Gli apparecchi in classe II devono essere
installati in modo che le parti metalliche
non siano in contatto con apparati elettrici
collegati a terra.
ATTENZIONE:Gli apparecchi in class I
devono essere collegati a terra.
-Questo apparecchio funziona a tensione
nominale,questa deve essere interrotta
prima di ogni intervento sul gruppo di
alimentazione.
-Ogni modifica dell' apparechio à proibita.
-Replace any cracked protective shield.
-Class II luminaires must be installed so
that exposed metal work of the luminaire
is not in contact with any part of the
electrical installation connected to a
protective conductor.
WARNING
:Class I luminaires must be
earthed.
-This luminaire operates at mains voltage
which must be switched off before
intervention in control gear.
-Any modification to this luminaire is forbidden.
-Lighted objects nearer than the minimal
distance in the is forbidden.
-Ersetze jede gebrochene Schutzscheibe.
-Schutzklasse II Leuchten müssen so
installiert werden,daß berührbare
Metallteile nich mit einem,an dem
Schutzleiter angeschlossenen Teil der
elektrischen Installation in Kontakt
kommen können.
ACHTUNG
:Schutzklasse I Leuchten
müssen geerdet sein.
-Diese Leuchte wird mit Netzspannung
betrieben.Bevor Eingriffe am
Vorschaltgerät vorgenommen werden
sowie vor Wartung und Installation,ist die
Versorgungsspannung abzuschalten.
-Jede Änderung an dieser Leuchte ist verboten.
FRANCAIS SVERIGE ITALIANO
-Rikkoontunut suojalasi vaihdettava
välittömästi uutsen vastaavaan.
-Asennettaessa suojausluokan II valaisinta
on peruseristetyn johdon ja kosketeltavien
metalliosien välinen kosketus tehokkaasti
eristettävä.
VAROITUS
:
Suojausluokan I valaisin
täytyy maadoittaa.
-Verkkojännite on kytkettävä pois ennen
valaisimen huoltotoimenpiteitä.
-Valaisimen rakennetta el saa muuttaa.
SUOMI
ENGLISH DEUTSCH
m
m
2
1, 2, 3
Question and Answer IconNeed help?

Do you have a question about the Thorn Champion and is the answer not in the manual?

Thorn Champion Specifications

General IconGeneral
BrandThorn
ModelChampion
CategoryFlood Light
LanguageEnglish

Summary

CHAMPION Luminaire Installation

General Safety and Class Requirements

Guidelines for Class II installation and Class I earthing. Warnings about mains voltage and modifications.

CHAMPION Type Overview and Specifications

Details product type, dimensions, mounting angles, and protection ratings like IK08, CE, IP66.

CHAMPION Luminaire Assembly Steps

Mounting Bracket and Luminaire Body Assembly

Step-by-step guide for attaching the mounting bracket and securing the luminaire body.

Cable Entry and Wiring Connections

Instructions for feeding cables and making electrical connections for Class I and Class II configurations.

Final Luminaire Housing and Securing

Details on closing the luminaire housing and final tightening of components.