Thrane&Thrane sailor 60 User Manual (English)

To Next Page

Document Name: SAILOR_60_90_Satellite_TV_Create_a_New_Satellite_List Revision:

Introduction: This document describes how a new satellite list can be generated for a new coverage area for the

SAILOR 60 and SAILOR 90 Satellite TV Antennas. This is needed to be done when the SAILOR

Satellite TV antenna is going to be used outside Northern Europe region which is the factory default

satellite list.

Description:

Install the NavSat PC program and USB driver for the SAILOR Satellite TV antenna.

Connect the USB cable from the PC to the SAILOR Satellite TV ACU and set the ACU in PC override

mode.

Start the PC program NavSat and press the Satellites button. See figure 1 below.

Figure 1: NavSat Main Window

The window with the satellite list will show. See figure 2 below.

TECHNICAL DOCUMENT

SAILOR 60/90 Satellite TV – Create a New Satellite List

Other manuals for Thrane&Thrane sailor 60

Need help?

Do you have a question about the Thrane&Thrane sailor 60 and is the answer not in the manual?

General