Document Name: SAILOR_60_90_Satellite_TV_Create_a_New_Satellite_List Revision:
D
Introduction: This document describes how a new satellite list can be generated for a new coverage area for the
SAILOR 60 and SAILOR 90 Satellite TV Antennas. This is needed to be done when the SAILOR
Satellite TV antenna is going to be used outside Northern Europe region which is the factory default
satellite list.
Description:
Install the NavSat PC program and USB driver for the SAILOR Satellite TV antenna.
Connect the USB cable from the PC to the SAILOR Satellite TV ACU and set the ACU in PC override
mode.
Start the PC program NavSat and press the Satellites button. See figure 1 below.
Figure 1: NavSat Main Window
The window with the satellite list will show. See figure 2 below.
TECHNICAL DOCUMENT
SAILOR 60/90 Satellite TV – Create a New Satellite List
To Next Page
Need help?
General
