12
ii) Using an external DC-DC charger or solar regulator.
• Your battery can be charged through the 50 Amp Anderson plug connection
via a DC-DC charger product or solar panel and regulator products
(sold separately)
Caution: Anderson connections have Positive (+) and Negative (-) symbols
inscribed on the plug to ensure correct polarity when connecting.
For your reference, The Weekender Anderson connection point is
wired according to these symbols.
• For the Weekender battery to accept an external charge, the master switch (4)
must be in the ON position.
• The Anderson connection is protected by an automatic 50 Amp reset circuit
breaker. Your maximum input charge current will need to be under this rating.
• Always ensure a qualified installer has fitted your external charger.
Refer to your purchased product for instructions on fuse protection,
locations and sizes and also correct cable selection.
• The LED display does not indicate the input charge current, only the battery voltage.
The Standard Accessory and Merit Accessory ports simply require the
connection of your 12 Volt accessory. All four sockets are protected by
separate 15 Amp automatic reset circuit breakers.
Always ensure the Weekender is mounted on an even, flat surface before
connecting to the accessories sockets, and all accessories are disconnected
before moving the Weekender.
Positive
connection
Negative
connection
CHARGING YOUR BATTERY IN
THE THUNDER WEEKENDER
USING THE
ACCESSORY PORTS
How To Use The Thunder Weekender
To Next Page
Loading...
Need help?
General