EasyManua.ls Logo

Thunderbird BD20 User Manual

Thunderbird BD20
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
THUNDERBIRD
Electric Fence Systems
Models BD20
Battery Powered Energizer
NOTE: READ ALL INSTRUCTIONS INCLUDING HELPFUL HINTS BROCHURE
BEFORE USING THIS FENCE ENERGIZER.
Thunderbird's battery range of energizers are highly efficient electrical appliances. Installed
and used correctly, these products should provide years of reliable service. These energizers
have protection against moisture and ant damage.
WARNING:-
1. Regular inspections of electric fences must be undertaken to ensure continued op-
erational safety and compliance. See - ‘INSTRUCTIONS FOR INSTALLATION AND
CONNECTION OF ELECTRIC FENCES FOR ANIMALS’ detailed over the page.
2. Persons coming into contact with high voltage pulses on a high output connection
may have their normal physiological functions interrupted.
3. Young children and infirm persons should not be left unsupervised in the vicinity of
an electric fence energizer or fence.
4. Do not connect to mains operated equipment.
5. Do not use copper wire. Electrolysis will occur and cause problems over time.
6. Output voltage reduces when the battery is near flat.
INSTRUCTIONS
Place the energizer in a suitable position for connection to the fence, preferably at the middle
of the fence line. Drive one or more galvanised earth stakes into the ground approximately
1m. Connect the live wire to the fence or red terminal, and the earth stake to the earth or
green terminal. Once all the fence has been installed, connect the red battery clip to the posi-
tive terminal of a 12V battery and the black clip to the negative terminal.
Correct earthing is extremely important. It is the other half of the electric fence. In dry con-
ditions or sandy soil, run an earth wire as well as the live wire as part of the fence, connect
any existing fence to the earth stakes, and drive in extra earth stakes every 1.5km. This ener-
giser has intelligent battery monitoring, if the battery starts getting flat the output voltage will
reduce to conserve the battery.
The top light flashes with every energizer pulse. The bottom light is a low voltage indication
that flashes with every pulse if battery voltage falls below 12.0V (nominal). If the battery
voltage falls to approximately 11.5V the low battery light will give a double flash every
pulse. Once the battery voltage falls to 11V the energizer will stop and the low battery light
will be continuously on. The energizer will start operating normally again when the battery
voltage exceeds 12V. These cutouts are intended to protect your battery.
These energizers have built in self testing. If there is a problem with the unit you will see
multiple flashes with each pulse. If the energizer pulse light flashes normally, and there is
low or no output, assume that there is a problem with the fence.
WARRANTY
THUNDERBIRD
Electric Fence Systems.
Thunderbird warrants all electric fence energizers against defective
workmanship and faulty materials for 2 years from the date of purchase.
We undertake, at our option, to replace or repair free of charge each
product, or part thereof, on condition that it is returned to our factory
freight pre paid, and found on examination to be suffering from material
or constructional defect.
We cannot be held responsible for any repair other than those carried out
by us or our authorised agents.
A proof of purchase must be returned with the goods if you are
claiming warranty. This can be in the form of a photocopy of your re-
ceipt. No warranty claim will be accepted without this information.
This warranty is void if the product is subjected to improper use or han-
dling, incorrect power input voltage, damage through contact with
chemicals, flooding, fire, explosion, excessive heat, lightning strikes,
insect damage, or damage to external wiring.
Country Electronics Pty Ltd
ABN 38 003 806 040
11 Industrial Avenue P.O. Box 391,
Mudgee NSW 2850 Mudgee NSW 2850
PHONE 02 63723600
FAX 02 63722597 Email : sales@thunderbird.net.au
For your records.
Model ……………………………………………………………………………
Serial No ………………………………………………………………………..
Date of purchase………………………………………………………………
Place of purchase ………………………………………………………………..
Receipt No ………………………………………………………………………..
Question and Answer IconNeed help?

Do you have a question about the Thunderbird BD20 and is the answer not in the manual?

Thunderbird BD20 Specifications

General IconGeneral
CategoryPower Supply
Output Power20W
Input Voltage100-240VAC
Output Voltage12VDC
ModelBD20
Protection FeaturesOvervoltage, Short Circuit

Summary

Warranty Information

Proof of Purchase Requirement

A photocopy of the receipt is required for all warranty claims.

Warranty Void Conditions

Warranty is void if product is subjected to improper use, incorrect voltage, or damage.

Safety Warnings

General Safety Precautions

Includes regular inspections, awareness of high voltage, supervision of children, and avoiding mains connection.

Material and Operational Warnings

Do not use copper wire. Output voltage decreases as battery depletes.

Installation and Operation Instructions

Energizer Placement and Connection

Place energizer centrally, drive earth stakes, connect live wire and earth.

Battery Connection and Monitoring

Connect battery clips to terminals. Intelligent monitoring reduces voltage as battery depletes.

Troubleshooting Indicators

Top light indicates pulse, bottom light indicates low voltage. Multiple flashes indicate unit problems.

Electric Fence Installation Guidelines

General Installation Safety

Prevent electrical hazards, entanglement, and use correct components for installation.

Wire and Connection Rules

Avoid barbed/razor wire electrification, maintain distances for separate fences, and use insulated cable.

Overhead Power Line Clearances

Maintain specified distances and height clearances when installing near overhead power lines.

Public Area and Warning Signage

Use non-electrified gates for public crossings and display clear yellow warning signs.

Product Specifications

Electrical and Performance Specs

Details input voltage, current, output voltage, and stored energy.

Wire Type Recommendations

Recommends hot tape, polywire, or galvanized wire based on fence length.

Energizer Features and Setup

Power Level Selection

Switch between low and high power levels for battery conservation.

D Cell Battery Installation

Instructions for removing the rear cover and inserting D cell batteries correctly.

External Battery Connection

How to connect the energizer to an external 12V DC battery.

Earth and Live Wire Connections

Steps for connecting the green earth lead and red live wire lead to the energizer.