P a g e | 3
Questions? Contact Customer Service @ 402-435-4249
PROGRAMMING REMOTE
1. Power on the keypad controller on the front of the trailer by
holding the Open and Close buttons on the keypad
simultaneously for 5 seconds or until the white light
illuminates to indicate the system is active.
2. Open the lid on the flip style remote and observe the
buttons illuminate indicating the remote is active.
3. Repeat step 2 for each remote to be programmed. Up to
four remotes can be programmed. Have all remotes ready
for steps 4 & 5. Ignore if only one remote is to be
programmed.
4. Press and hold the small Program & Open buttons on the
keypad mounted on the trailer simultaneously until the light
turns green. Release the buttons which will cause the status
LED to quickly flash red/orange.
5. Press and hold the TARP OPEN button on the remote for 2
seconds OR until the red/orange flashing light momentarily turns
white on the keypad, then release the button. Keypad light should
then continue blinking red/orange.
6. Repeat step 6 for up to four remotes to be programmed. Ignore if
only programming one remote.
7. Once all remotes are programmed press and release the program
button to exit programming mode or keypad will also time-out after 10
seconds.
8. The keypad status LED will blink twice red indicating the remote(s)
have been saved to memory.
If above steps do not result in the remote being programmed,
unplug the trailer from power, wait 15 seconds, replug power, then
repeat the programming steps.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This device complies with Industry Canada licence-exempt RSS-xxx standard. Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
OPEN
Program
To Next Page
Loading...