05. Display/Switches introduction
1
）
Turn on/off the scooter: Long press power button (around 3 seconds).
2
）
Light on/off: Long press mode button (around 3 seconds).
3
）
Switch speed gear: Short press mode button to change speed gear (1, 2, 3).
4
）
Mode function: Short press the power button to change the mode:
TIME>TRIP>ODO>VOL.
TIME: Ride time for a single ride
TRIP: Mileage for a single ride
ODO: Scooter’s total mileage
VOL: Battery voltage
5) Throttle error troubleshoot
-Brake sensor error: Brake sensor triggered. Try to check if the brake
levers and cables are stuck, or if the sensors are faulty.
-Controller fault: Internal controller may be faulty. Check if it is
damaged by water or burnt, may need to replace controller.
-Motor fault: Motor issues, open and check if the motor cables are
intact. May need to replace motor.
-
Throttle fault: Check throttle display’s internal spring and magnet
sensor. You will need to open the back cover of your throttle display to
troubleshoot it. 8
To Next Page
Loading...