Danger
!
Battery disassembly prohibited: B
attery disassembly, modification and repairment are not
covered under warranty.
08. Safety guidelines before driving
Required checking before use
Step 1: Check throttle and handle
* Operate the accelerator throttle lever about 2 ~ 3 times to check whether it returns to
the home position.
* Be careful that excessive throttle Leaning and manipulation of the throttle can cause
malfunction due to internal parts damage.
* Check the fastening condition and clearance of the QR lever on the handle.
Step 2: Check brake and cable
* The brake braking force is sufficient to check the operating condition. If the braking
force is significantly lowered, use it immediately after inspection and action.
* Check that the brake pad is not worn, that the cable is not loose and that the cable is
not damaged.
* If there is an unusual feeling or noise during operation, check for breakage, wear and
deformation of the inner wire of the brake cable.
* Check that the bolts and nuts of the brake fixing parts are not loose.
Step 3: Check tire pressure and uniaxial condition
* Check the front and rear tires for wear and punctures and check the proper air
pressure (45 to 50 psi) for the tire. When the shortage of air is shortened, the possibility
of puncture increases, so check always.
* It is necessary to judge the replacement time by observing the appearance of the tire
such as tire damage, uneven wear.
Step 4: Tightening check such as folding part and handle part
Make sure that the bolts and nuts of all parts of the product are tight and free from
loosening. Check the fastening condition and clearance of the folding and fixing parts
of the handle.
12
To Next Page
Loading...