WARNING: If button stop
cable is showing
DO NOT TOW TRAILER
Release emergency stop
cable by prying spring out
with a flat blade
screwdriver.
Emergency
Button Stop
Shown in normal
operating position
Emergency Button Stop
Push the screwdriver forward and back to
pump the master cylinder. (See 2B).
The bleeding operation for that brake is
complete when bubbling stops. Be sure to
tighten bleeder screw securely. Each wheel
cylinder must be bleed until all air is out of
the lines. Replenish the brake fluid during the
bleeding process so the level does not fall
below half full level in the master cylinder
reservoir.
When bleeding and testing is completed, make
sure master cylinder is filled to 3/8” below the
top of the reservoir and filler cap is securely
in place.
Page 8
To Next Page
Loading...
Need help?
General
