Tiffany WDV225 - Usage and Maintenance; Picking Up Liquids or Wet Debris; Cleaning and Maintenance

Picking up liquids or wet debris
1. Never use the appliance to suck up any other liquid than cold water.
2. Use the liquid suction attachment to pick up liquids or wet debris.
3. Do not exceed the MAX fill line when sucking up liquids (the MAX fill line must always be measured
when the appliance is in the vertical position, with the suction inlet facing down).
4. When picking up liquids, always keep the vacuum in the vertical position, with the suction inlet
facing downwards. Never place the appliance in any other position and never allow liquids to come
into contact with the motor.
NOTE: Empty the canister immediately after use and wash the filter.
NOTE: Rinse the canister and the filter in cold water and let all parts dry completely before reassembling.
CLEANING & MAINTENANCE
Emptying the canister & removing the filter:
1. Whilst holding the canister in one hand and the vacuum handle in the other, press the canister
release button and unclip the dust canister.
2. Once the canister is removed, remove the dust filter by pulling it out of the canister and empty the
contents of the canister into the bin.
3. Clean the filter and if necessary clean the inside of the canister with a dry cloth.
4. Replace the filter in the canister and clip the canister back onto the vacuum.
NOTE: After intensive use, or once you have had the vacuum for a long time, it is necessary to replace the
filter.
WARNING: Do not use the device if the filter is broken or worn out.
Cleaning tips:
• Before cleaning the device, always remove it from the charging base and make sure it has
completely cooled down and is switched off.
• Wipe the exterior of the unit with a soft damp cloth; never use abrasive cleaning agents on any part
of the vacuum.
• To avoid the risk of electric shock, do not clean the charging base with water or any other liquid.
Only use a soft dry cloth.
• The dust canister and filter are the only parts that can be washed in cold water. The parts must be
completely dry before reassembling.
• Do not immerse the body, handle, power supply cord, charging base, or the transformer in water or
any other liquid.
• This product is not dishwasher safe.