Tiger SUMATRAN - Step 8: Roof Felt Application; Preparing Felt for Installation; Measuring and Cutting Felt Strips; Laying Felt on Low Side of Roof

To Next Page

To Previous Page

Pleaseretaininstruconsforfuturereference

Step 8:

FELT THE ROOF - MEASURE AND CUT BEFORE INSTALLING FELT

• Rollfeltoutontoacleanatsurface30minutesbeforeyouneeditsoithasachancetoaenout.

• Measurelengthofroofandallow75mmoverhangateachend.Cuteachstripoffelttosize.

 Useastraightedgetoguidecung.

• Rollcutfeltpiecealonglowsideofroof,Secon1,leavingsucientoverhangtofolddownontoroofedge.

 Donotfoldunderneathroof.

(Detail G1 & G2)

• Oncefeltisrolledout,xtoroofusingCN20bothends,makingsurefeltisstraight.Securethroughskirng

 usingCN20atapprox.100mmintervals.

(Detail G2)

 Ensurethefeltisght,securethetopsideoffeltusingCN20atapprox.100mmintervals.(Detail G3)

• Repeatforremainingfelt,workingfromthelowsideofrooftothehighside,overlappingthefeltby75mm

 unltheroofisfullycovered.

(Detail G3)

• Foldtheoverhangingfeltatendsunderroofboardandtackinplace.

G1 G2 G3

INCORRECT FELT CORRECT FELT

CN20

ROOF BOARD

SECTION 1