SignaLink
TM
USB
154 Hillview Drive Grants Pass, Oregon 97527
(541) 474-6700 Fax: (541) 474-6703 www.tigertronics.com
Installation & Operation
- INTRODUCTION -
The SignaLink USB combines the legendary performance of
our SL-1+ with a state of the art built-in low-noise sound
card. This innovative design offers many advantages over
traditional sound card interfaces that must use the
computer’s sound card. These include optimal performance,
greatly simplified installation and operation, and the ability
to easily run multiple interfaces on one computer at the
same time.
The SignaLink USB supports ALL sound card Digital and
voice modes. This includes “legacy” modes such as RTTY,
SSTV and CW, as well as today's most popular modes like
PSK31, MT-63 and EchoLink. Performance on all modes
has been optimized by the use of special low-noise parts and
careful design techniques, while convenient front panel
controls let you adjust your Transmit Audio, Receive Audio
and Transmit delay "on the fly".
The SignaLink USB is designed and manufactured using
only the highest quality components. Assembly is done
using “state of the art” robotic production equipment. Strict
testing of every unit, and our high level of quality control
insures you of a premium quality product that will provide
many years of dependable service. A great deal of effort has
gone into the design and manufacture of the SignaLink
USB, and we think you’ll agree that we have offered a level
of innovation, quality, and value that cannot be beat!
- INSTALLATION OVERVIEW -
The SignaLink USB is easy to install and operate. However,
if it is not installed and operated correctly, you will not
realize its best performance and in extreme cases you can
damage your other equipment. Therefore, it is extremely
important that you take the time to read these installation
instructions carefully to avoid any possible problems.
The SignaLink USB will be installed in two steps. First you
will install the jumper wires, and then you will connect the
unit to your computer’s USB jack. If after completing the
installation you have any difficulty, please refer to the
“Troubleshooting” section at the end of this manual. It
covers most of the common problems that you might run
into. Technical Support for the SignaLink is also available
if you need it. Please see the “Technical Support” section of
this manual for more information.
- WHAT YOU WILL NEED -
The SignaLink USB is supplied with everything needed to
connect to your computer and radio. If the SignaLink
jumper settings for your radio are not available on our web
site or CD, then you will need a multi-meter to verify your
radio wiring. Some customers may find needle-nosed pliers
to be helpful when installing the jumpers. You will need
software for testing when the installation is complete. We
have supplied some of the most popular programs for the
most popular modes on our software CD. You can also
download additional software from the main page of our
website at www.tigertronics.com.
- OPENING THE SIGNALINK USB CASE -
To open the SignaLink USB, we suggest that you open the
FRONT of the unit while leaving the three knobs attached.
This can be done by removing the four front Allen screws
with the supplied Allen wrench, and CAREFULLY sliding
the circuit board and front cover forward. To avoid
scratching the front panel or damaging the SignaLink’s
front panel controls, we strongly suggest that you sit the
circuit board on a book or other raised insulated surface
when installing the jumper wires. When you are ready to
re-assemble the SignaLink USB, CAREFULLY slide the
circuit board back into the case and re-install the four Allen
screws (note that the circuit board sits on the bottom most
rail). If you have any difficulty re-installing the circuit
board, you can remove the rear panel to make it easier.
Grants Pass, Oregon
To Next Page
Need help?
General
