TDFM-136B
Quick Reference Guide
For Radio Firmware: 1.x.x
1. LED channel squelch indicators – Lights when signal received (Top: Main, Bottom: Guard).
2. Channel parameter display – (2 line by 24 character LED display) (Top: Main, Bottom: Guard).
3. MAIN Multi-function rotary encoder (default: Main volume, press for ON, press & hold for OFF).
4. GUARD Multi-function rotary encoder (default: Guard volume, press for Squelch defeat).
5. Data port – for use with KVL 3000+ keyloader or TDP-136 Programming software.
6. MN/GD (Toggle Switch) – Selects active channel (main or guard), for transmit and edit.
7. G1/G1 (Toggle Switch) – Selects guard memory (GD1 or GD2), for transmit and edit.
8. HI/LO (Toggle Switch) – Selects transmit power, high (10W) or low (1W).
9. KEYPAD (12 Keys) – Control radio functions, 3 command levels as shown below.
Command Level 1: press the 'Cmnd' key. . .
Cmnd Function Edit Keys OK Exit
SELECT MEMORY
TO ENTER CHANNEL MEMORY (001 to 230)
DISPLAY BRIGHTER
EDIT OPERATING MODE
STEP UP/DOWN THROUGH OPERATING MODES
SCROLL MEMORY DOWN SCROLL DOWN THROUGH THE PROGRAMMED MEMORY POSITIONS
SCAN ON/OFF
OR STOP SCAN
SCROLL MEMORY UP SCROLL UP THROUGH THE PROGRAMMED MEMORY POSITIONS
EDIT FREQUENCY
TO SELECT FREQUENCY THEN Tx FOLLOWS Rx.
DISPLAY DIMMER
EDIT SQUELCH MODE
STEP UP/DOWN THROUGH SQUELCH MODES. Tx FOLLOWS Rx.
EDIT SQUELCH VALUE
STEP UP/ DOWN THROUGH: TONES, CODES, TG & NAC (HEX)
TO DECIMAL EDIT FOR NOISE SQL VALUE (00 TO 15)
GO TO NEXT LEVEL GO TO THE NEXT HIGHER COMMAND LEVEL
TOGGLE HOME/CURRENT TOGGLE BETWEEN 'HOME' MEMORY AND CURRENTLY DISPLAYED MEMORY.
TOGGLE TALK AROUND IF DUPLEX MEMORY, THEN USE RX PARAMETERS FOR TX.
TiL 08RE394
To Next Page
Need help?
General
