Mount the chain guard supplied and fasten via the supports provided.
Fit the outer and inner throttle cable from the chassis to the carburettor – check that the accelerator
pedal is hitting the cable stop so it will not stress the throttle cable and confirm you are reaching full
throttle from the carburettor.
Fit the fuel line from the fuel tank to the carburettor. Also it can be advised to mount an option in-
line fuel filter which are available such as the Tillotson FS-1 filter
Ensure the overflow bottle from the fuel tank has a hole drilled to vent the fuel tank.
Mount Tyres
Fit the Tillotson Racing Decals to the T4 Kart using heat gun if necessary to soften the material
Double check each nut and bolt is tight
Fill with Fuel
Proceed to Running-in Procedure for the Engine.
To Next Page
Loading...