Remote controller (g. 3)
The remote controller should be directed to the signal receiver, located on the control unit.
The control unit conrms receipt of a control command by a sound signal.
Mounting of batteries
The remote controller is power supplied from two AAA batteries (not included in the scope
of delivery), installed in a special compartment whose cover is located on the back panel of
the remote controller. To mount batteries:
1. Remove the cover of the battery compartment by sliding it along the direction of the
arrow.
2. Mount batteries, observing specied polarity.
3. Place the cover back.
IMPORTANT!
1. Prevent contact of the remote controller with water and other liquids. Prevent
contact of the remote controller with direct sunlight and do not leave it nearby
heaters and electric appliances.
2. Prevent contact of direct sunlight with the infrared signal receiver.
8
6
www.timberk.com remote control block
To Next Page
Loading...