Page 2
3) Using the wrench provided, place the
Driver into the square of the wrench
and tighten the setscrew to secure the
driver in place. Picture E.
Oil the bottom threads of the insert
driver with a few drops of driver oil.
Picture F.
E:
F:
4) Screw and insert onto the driver and
into the newly prepared hole.
Picture G.
While screwing the driver into the
insert you will feel the driver start to
tighten up, with a little more power
continue through the insert until it
loosens up. The driver will cold form
the last few threads of the insert locking
it in place. Picture H.
Remove driver, repair is complete.
G:
H:
The new steel threads are now square
to original piloted spark plug hole.
www.timesert.com
To Previous Page
Loading...