Timewave DSP-59+ - Page 17

16
Back Panel Jumper Table
Internal Jumper (JH1)
Function 12345678 Setting
Audio Input Resistance on xxxxxxx 22 ohms
Audio Input Resistance off xxxxxxx 2k ohms
Voice Noise Reduction
Aggressiveness (NRr)
xononxxxxx Least Aggressive
Voice Noise Reduction
Aggressiveness (NRr)
xoffonxxxxx Less Aggressive
Voice Noise Reduction
Aggressiveness (NRr)
xonoffxxxxx Normal
Voice Noise Reduction
Aggressiveness (NRr)
xoffoffxxxxx Most Aggressive
reserved x x x on xxxx
reserved x x x off xxxx
Option 1 xxxxonononon1700 Hz. Center Freq.
Data
Option 2 xxxxoffononon1360 Hz. Center Freq.
Data
Option 3 xxxxonoffonon1300 Hz. Center Freq.
Data
Option 4 xxxxoffoffonon1530 Hz. Center Freq.
Data
Option 5 xxxxononoffon2125 Hz. Center Freq.
Data
Option 6 xxxxoffonoffon 1350 Hz.
CW - Collins
Option 7 xxxxonoffoffon 1500 Hz.
CW - Collins
Option 8 xxxxoffoffoffon 1750 Hz.
CW - Collins
Option 9 xxxxonononoff 300 - 2700 Hz.
Marker = 1.0 kHz.
Option 10 xxxxoffononoff 300 - 2700 Hz.
Marker = 1.0 kHz.
Option 11 xxxxonoffonoff 300 - 2700 Hz.
Marker = 1.0 kHz.
Option 12 xxxxoffoffonoff 300 - 2700 Hz.
Marker = 1.0 kHz.
Option 13 xxxxononoffoff 300 - 2700 Hz.
Marker = 1.0 kHz.
Option 14 xxxxoffonoffoff 300 - 2700 Hz.
Marker = 1.0 kHz.
Option 15 xxxxonoffoffoff 300 - 2700 Hz.
Marker = 1.0 kHz.
Option 16 xxxxoffoffoffoff Reserved
Note:
1. "x" indicates the jumper does not affect the function or setting on its row.
2.
BOLD
type indicates default factory setting.