Timex 100 - Page 7

Lubricating the Model100 Movement
INTERMEDIATE WIND
PINION AND STEM WIND PINION
RATCHET
PALLET STAFF
PIVOT
ESCAPE PINION
~~""'~!=~~~-PIVOT
The Timex Model l 00 movement
should
be lubricated using only
High Grade Watch Lubricants. The
Mainspring is permanently lubri-
cated
with a dry film lubricant
which is not affected by normal
watch cleaning solutions, therefore
the Mainspring requires no lubrica-
tion.
DIAL PLATE
PIVOT
STUD AND MINUTE PINION
Spreading Type Watch Oil (Woods
AAAA Oil is used in the factory) is
put at two points at the side of the
main
arbor having the greater gap
between the ratchet wheel washer
and the main arbor. Also put
spreading type oil on the main
arbor on the movement plate side
and on the sweep second staff
where it passes through the post
at the center of the Dial Plate.
HOLE TO FOURTH
PINION BEARING
THIRD PINION
PIVOT
INTERSECTION OF ROCKING BAR
AND SET LEVER
100.6
FOURTH PINION
PIVOT
FIGURE A
Lubricate teeth of ratchet wheel
and click with non spreading watch
oiL
PIVOT Lubricate the movement as noted
on Figure A (front view) and Figure
B
(rear view) with a non-spreading
type oil (Moebius Synt-A-Lube is
used in the factory ).
PIVOT
FIGUAE B