22
Configure Mode
Use Configure Mode to customize all of the settings on the Global Trainer™ Bodylink® System Watch, from
time settings to sensor pairing to GPS settings.
Hands Free
Hands Free settings control automatic starting, stopping, and splits on the chronograph.
To Configure Hands Free Setting
1. Press MODE until CONFIGURE displays.
2. Press q to highlight HANDS FREE, then press 8 .
3. Press q to highlight a submenu, then press 8 . The selected configure screen opens.
4. Press p or q to highlight the setting to change, then press 8 to open the setting change window.
5. Press p or q to highlight a selection in the setting change window, then press 8 to confirm your selection.
Settings on each Hands Free submenu are detailed below.
Auto Start/Resume
Setting Group Adjustment
Auto Start Select ON to start the chronograph automatically when you move at or above the
speed threshold. Select OFF to disable auto start.
Auto Resume Select ON to restart the chronograph automatically after you stop and then begin
moving again at or above the speed threshold. Select OFF to disable auto resume.
Speed Threshold Enter the speed at which the chronograph will automatically start. Press 8 to close
the setting change window. The minimum is 0.10. The maximum is 99.99.
Auto Stop
Setting Group Adjustment
Auto Stop Select ON to stop the chronograph automatically when you go below the speed
threshold. Select OFF to disable auto stop.
Speed Threshold Enter the speed at which the chronograph will automatically stop. Press 8 to close
the setting change window. The minimum is 0.1. The maximum is 99.99.
To Next Page
Loading...
Need help?
General