1 Power off. Pull out the temperature
senor on the mainboard.
.
Replace it by the standard sensor
Correct the parameter of sensor for 12/16-A
2. Press the START button before Power on.
Then holding the button for about 30 seconds until
you heard a sound of di di
3. The pressure display will show .1
4. Press the COTTON button to adjust to P as the
picture.
5. Press the SOLID
button. Then you will heard a long sound and four
short sound. That means the adjustment success.
Make sure the door is opening.
6. Press the START button. Then power off. And replace
the standard sensor with the temperature sensors.
8
To Next Page
Loading...