FACTORY SETTINGS
•IP address of the module: 192.168.1.100
•administrator: admin password: admin
•user: user password: user
TECHNICAL SPECIFICATIONS
•supply voltage: 8 ÷ 55 V DC
•power consumption: 0,5W - without an attached relays
•PoE supply: YES, passive (PoE max. <55 V)
•Protection from wrong supply polarization: YES
•interface: Ethernet 100 Mbit/s
•relay: 255 V AC 10 A
•operating temperature: –20 to +85 °C
•weight: 50 g
•dimensions: 67 x 68 x 39 mm + DIN socket (can be mounted on DIN rail)
INPUT / OUTPUT:
•4 ANALOG INPUTS INPA1÷INPA4 WITH AMPLIFIER - 2 input voltage ranges:
The scope of of measured voltage for a range of 3.3 V
gain=1 from 0 to 3300 mV
gain=10 from 0 to 330 mV
gain=50 from 0 to 60 mV
The scope of of measured voltage for a range of 33 V
gain=1 from 0 to 33000 mV
gain=10 from 0 to 3300 mV
gain=50 from 0 to 600 mV
for voltages between 0 ÷ 5 mV, the measurement is not sure.
•2 ANALOG INPUT WITHOUT GAIN INPA5÷INPA6:
range of measured voltage of 0.1÷3.3 V
•1 DIGITAL INPUT in standard 1-WIRE and I2C (connector 6P6C RJ12):
measurement 6 temperature probes DS18B20 and the temperature and humidity sensor AM2320
•4 LOGIC INPUT:
VLow - max 1,1 V
VHigh - min 1,5 V, max 12 V
•1 RELAY:
10 A / 240 V AC, 15 A / 24 V DC
3 styki: NZ, NO, C
•1 TRANSISTOR OUTPUT:
giving adequate voltage to control receivers with current consumption up to 1A
•4 OUTPUT OUT1÷OUT4 (connector IDC10-2):
OC output of 100 mA, controlled downside to switching relays, transistors, etc.
•4 PWM OUTPUT:
the output frequency range of 50 Hz to 100 kHz
•UART - serial - console preview functioning of the Lan Controller system:
Transmission parameters: 115200 bitrate, 8 N 1
To Next Page
Loading...