TIP SPF 180 E - User Manual

Questions and Answers

M
Marie ClarkAug 5, 2025
What to do if my TIP SPF 180 E Swimming Pool Filter pump is not discharging liquid but the motor is running?
- J
  Jorge HayesAug 5, 2025
  If your TIP Swimming Pool Filter pump motor runs but no liquid is discharged, several factors could be at play. First, ensure the pump housing is filled with liquid and that the water level in your pool is above the pump's suction point, also verify the strainer is free of dirt. Second, check for air leaks in the intake line, ensuring all connections are tight and that there are no kinks or narrow spots in the lines. Finally, inspect the check valve (non-return valve) for blockages or damage; clean or replace it as needed, and also check the pump insert and impeller for any blockages.
G
garciatimothyAug 13, 2025
Why does my TIP SPF 180 E pump stop after a short time?
- D
  diana29Aug 13, 2025
  Your TIP Swimming Pool Filter pump might stop shortly after starting due to the thermal motor protection being triggered. This could be because the electrical supply doesn't match the type plate information. The pump or intake openings may be blocked by solids, so remove any obstructions. The liquid temperature might be too high, ensure it does not exceed the maximum admissible value. The pump could also be running dry, so eliminate the causes of dry-running.
B
Brian ChavezAug 20, 2025
How to troubleshoot a TIP SPF 180 E pump that is not running?
- A
  Allison WeaverAug 20, 2025
  If your TIP Swimming Pool Filter pump isn't running and not discharging liquid, there could be several reasons. First, check for a power supply. Second, the thermal motor protection feature may have been triggered; in this case, disconnect the pump from the power, let it cool, and identify what caused the trigger.
L
Laura Parker MDAug 28, 2025
How to fix noise in my TIP SPF 180 E Swimming Pool Filter pump?
- P
  Peter MartinAug 28, 2025
  To address noise issues in your TIP Swimming Pool Filter pump, start by checking and cleaning the suction hose to eliminate any blockages during aspiration. Improve the suction inlet by ensuring it's submerged under the water level, reducing the number of screws, and using a pipe with a larger diameter. If air is entering the intake line, refer to section 2 of this table for guidance.