Tippmann CUSTOM PRO - Marker Specifications and Model Details

17
E
N
G
L
I
S
H
Specifications
Model Basic ................................Tippmann
TM
CUSTOM PRO
TM
Caliber ................................................................................. .68
Action .......................... Semi-Automatic (open bolt blow-back)
Power/Air Supply ...................... compressed air, nitrogen or CO2
Hopper Capacity ............................................... 200 Paintballs
Cycle Rate ..................................................8 shots per second
Standard Barrel Length ....................................................... 11”
Overall Length (with standard barrel & no tank) ................. 21”
Weight (without tank) ..................................................... 2.9 lbs.
Effective Range ............................................................ 150+ ft.
Velocity ..................... Always measure your marker’s velocity
before playing paintball and never shoot at velocities in
excess of 300 feet per second (see instructions on page 7).
Model Specific ....Tippmann
TM
CUSTOM PRO
TM
RESPONSE
TM
Cycle Rate ............................................... 15 shots per second
Weight (without tank) ...................................................3.05 lbs.
Model Specific..Tippmann
TM
CUSTOM PRO
TM
WITH E-TRIGGER
TM
Cycle Rate ............................................... 17 shots per second
Weight (without tank) ................................................... 3.19 lbs.
When removing your marker out of storage make sure Barrel
Sleeve is installed (see page 2) and safety is in Safe Mode
(see page 4). You should re-oil the rear bolt and the front bolt
o-ring before use.
Model Specific Parts Not Shown on CUSTOM PRO
TM
schematic.
CUSTOM PRO
TM
RESPONSE
TM
CUSTOM PRO
TM
WITH E-TRIGGER
TM
20-26 Shut Off Plug
20-07 Flow Control 90
0
Fitting
20-18 Flow Control Hose
20-03 Flow
Control Valve
20-07 90
0
Fitting
20-05 Cylinder Hose
20-04 Cylinder 90
0
Fitting
20-20N Cylinder
02-91 Armature Pin
02-90 Sear Tripper
Assembly
TA05014
Magnet
(Armature
fits inside
bottom of
solonoid)
02-88
Sear Spring
TA01135
Sear
Storage (continued from page 16)