Tissot Chronograph User Manual

Chronograph with alarm
*
www.tissot.ch
124_EN / 12/09
3/4
Setting the counters to zero
Crown in position II
In exceptional circumstances, the counter hands may not be set at or return to the 0 position (12 o'clock). In
this case, press each pusher to reset the hands concerned to zero:
A Sets the 30 minute counter hand to zero
B Sets the 60 second counter hand to zero
D Sets the 12 hour counter hand to zero
Note:
Brief pressure on the pusher advances the hand incrementally.
Extended pressure (>1 sec.) on the pushbutton advances the hand rapidly.
Alarm
Crown in position I
Select the «ALARM»(e.g.:AL/Am)bypressingpusherD for < 1 second.
Notes :
The display of the ALARM function in the left aperture of the digital display (AL) is automatically followed by
thedisplayofthealarmhours(leftLCDaperture)andofthealarmminutes(rightLCDaperture).
 Activate the flashing of hours and minutes of the alarm by pressing pusher C for < 1 second.
 Correct the alarm hours with pusher C.
 Correct the alarm minutes with pusher B.
Crown in position I
Oncethehoursandminutesofthealarmareset,activateordeactivatethealarmasfollows:
 Return to « ALARM/DATE » mode by pressing pusher D for < 1 second.
 Select the alarm status « ON/OFF » by pressing pusher C for > 1 second.
Notes :
An audible signal indicates that the alarm is switched on (ON). You can also check that the alarm bell is
working properly by pressing pusher D (alarm demo mode).
When programming the alarm, ensure that the analog time (hands) matches the digital time
(indicators on left/right sides). If the times indicated are not identical, please refer the paragraph
entitled “Setting the time".
Chronograph (simple function)
The simple « chronograph function » enables you to measure isolated events.
Crown in position I
START/STOP
STOPgReading the time
 Reset counters to zero
Note:
Before each timing operation, the chronograph hands must be reset to zero..
If necessary, refer to the paragraph entitled "Setting the counters to zero".
60
20
40
30
20
10
12
3
6
9
14
57
D
C
A
B
60
20
40
30
20
10
12
3
6
9
3
2
D
C
A
B
4
1
60
20
40
30
20
10
12
3
6
9
D
C
A
B
5
6
60
20
40
30
20
10
3
6
9
Ad
74
1
2
3
D
C
B
A
Correction of month and date
Crown in position III
 Select the « MONTH/DATE » mode using pusher A.
 Correct the date using pusher B.
 Correct the month using pusher C.
Note:
Everytimealeapyearoccurs,yourwatchwillchangefrom28Februaryto1March.Youthereforeneedtoset
29 February by hand, in the following manner :
– Put the setting crown in intermediate position (II) (correction of time zones).
– Turn the hour hand twice anti-clockwise (2 full turns).
– Return the setting crown to position I.
60
20
40
30
20
10
12
3
6
9
D
C
A
1
2
3
B

Tissot Chronograph Specifications

General

Brand	Tissot
Model	Chronograph
Case Material	Stainless Steel
Case Diameter	42 mm
Water Resistance	100 meters
Crystal	Sapphire
Functions	Chronograph, Date
Strap Material	Stainless Steel
Strap Color	Silver
Movement	Quartz