What to do if the Check Transducer screen appears on Titan Tool IMPACT 840 Paint Sprayer?
If the Check Transducer screen appears on your Titan Tool Paint Sprayer, it indicates the transducer is either disconnected or defective. In this case, take the sprayer to a Titan authorized service center for repair.
What to do if the Check Potentiometer screen appears on Titan Tool IMPACT 840?
If the Check Potentiometer screen appears on your Titan Tool Paint Sprayer, it means the potentiometer is either disconnected or defective. The solution is to take the sprayer to a Titan authorized service center for repair.
What to do if the High Motor Temperature screen appears on Titan Tool Paint Sprayer?
If the High Motor Temperature screen appears on your Titan Tool Paint Sprayer, take the sprayer to a Titan authorized service center for repair.
What to do if the High Mechanical Load screen appears on Titan Tool Paint Sprayer?
If the High Mechanical Load screen appears on your Titan Tool Paint Sprayer, the solution is to take the sprayer to a Titan authorized service center for repair.
What to do if Titan Tool Paint Sprayer shuts down because of low input voltage?
If your Titan Tool Paint Sprayer shuts down due to low input voltage, check the power supply and correct the problem. Then, restart the sprayer by following the 'Painting' procedure in the Operation section of this manual.
Essential grounding procedures to prevent electrical shock.
Key safety guidelines for operation, environment, and personal protection.
Step-by-step guide for preparing the sprayer before use.
Initial cleaning process for new sprayers before first use.
Steps for loading paint and performing the actual spraying.
Details on the Digi-Trac™ system for monitoring and customization.
Critical steps for safely relieving system pressure before servicing.
Instructions for cleaning the sprayer, hose, and gun after use.
General guidelines for sprayer maintenance and required tools.
Procedures for servicing valves and repacking the fluid section.
Diagnosing and resolving issues with the unit not starting or priming.
Addressing issues with pressure loss, surge, or poor spray patterns.
General| Power Source | Electric |
|---|---|
| Voltage | 120 V |
| Type | Airless |
| Filter | Included |
| Orifice Size | 0.021 in |
| Tip Size | 0.021 in |
To Next Page
