3cm
If the inserts are not in the legs please place 1 top and 1 bottom insert into each of the 4 legs supplied.
(Round inset goes to the bottom of the leg and pointed inset goes to the top of the leg.
To the bottom of the brooder hen (Silver side) there are
four leg mounting plates, each one has a clip that you
push to allow the leg to be fitted into the brooder hen.
Push this clip and lower the leg down through the
brooder hen with the flat lower insert going to the
lower side of the brooder hen. Release the clip to lock
the leg in place. Repeat for all 4 legs.
How to Set Up
Plug the unit in and ensure the silver side faces down, allow upto 60
minutes for the brooder hen to get to the correct heat.
ENSURE the brooder hen is a minimum of 3cm above the litter/bedding
you are using for the chicks.
To Next Page
Loading...
Need help?
General
