1
2
3
4
5
6
7
89
10
11
12
13
14
15 16
8
13
NAME AND FUNCTION OF EACH PARTNAME AND FUNCTION OF EACH PART
Description on VFD display area
1.Time display area: It displays the remaining time during massage. The
default time is 20 minutes.
2.Auto mode display area of back massage This icon will be lightened
when the back massage unit works in the following six auto modes:
RECOVERY , EXTENT , RELAX , REFRESH , UPPER BACK AUTO ,
and LOWER BACK AUTO , while this icon will not be lightened under
other modes.
3. Display area of back massage technique: It shows the current back
massage technique.
KNEAD TAP WAVELET PUMMEL SHIATSU RHYTHM
4. Display area of back massage locate mode
Overall locate mode: locating at the whole back.
Partial locate mode: centering on current massage point; the
massage area is the one third of the whole.
Point locate mode: Staying on current position, and by pressing
UP/DOWN button to change current massage point.
5. Display area of massage chair ascending and descending adjustment
Legrest ascending and
descending dynamic indication
Backrest ascending and
descending dynamic indication
6. Shoulder position adjustment and back massage unit resetting
6.1 Indicator of back massage unit resetting
6.2 Datum mark: The central point of back massage unit, when
it begins to adjust, is the starting point, and the corresponding
actual moving distance of every interval is about 2 cm.
6.3 The position of massage unit with respect to datum mark
during adjustment.
PREPARATION BEFORE USEPREPARATION BEFORE USE
Step 5:
Fix the back cushion onto backrest with zipper, fasten the big and small
pillows with Velcro, and insert the plugs of backrest and seat cushion as
shown on the picture below.
Zipper
Plug of heater
Step 6:
Align the mounting holes of controller support with the four holes of
armrest, and then fix them with four screws. (The DVD mounting bracket
has the same installation method with it.)
6.1
6 .2
6.3
To Next Page
Loading...
Need help?
General
