Titan Telescoping Flagpole User Manual

Titan Flagpole Installation and Operation Instructions
2020
How to Install Your Titan Telescoping Flagpole
Read instructions completely.
Select the location for your flagpole
and be sure that there are no
obstructions; utilities or power
lines beneath the surface or
overhead.
Tools You Will Need: Shovel, Spade or Post Hole Digger, Tape
measure, Level, Container to mix concrete.
Materials You Will Need: 240lbs of pre-mix concrete, water and 15-
20lbs of Pea Gravel or Crushed Rock
Install the stop bolt completely
through the pre-drilled hole in the
ground sleeve. Hand tighten only.
Mix the concrete according to the
manufacturer’s instructions.
Dig a round Fence Post Size hole,
14” in diameter and 28” deep. A
larger hole may be required for soft
or sandy soil.
Be sure that your hole is at least
the size stated in the previous step.
Now shovel in 4-6” of gravel into
the bottom of the hole. This will
provide water drainage.
If you fail to push the sleeve into the
gravel, it will allow the concrete to
seal the hole and prevent water
drainage.
Use your “red cap” to cover the
ground sleeve. Begin to shovel the
concrete into the hole around the
ground sleeve being careful not to
disturb the sleeve position.
Push the sleeve into the gravel while
making sure that the ground sleeve is
at least 1” above ground level.
Remove the red cap to check the
sleeve for plumb with a level in
several locations. Install the red cap
into the sleeve to prevent foreign
objects from entering sleeve.
After a minimum of 24 hours of
drying time, take off the red cap,
place your flagpole into the hole.

Titan Telescoping Flagpole Specifications

General

Brand	Titan
Model	Telescoping Flagpole
Category	Lawn and Garden Equipment
Language	English

Summary

How to Install Your Titan Telescoping Flagpole

Site Preparation and Hole Digging

Read instructions, select location, ensure no obstructions, dig 14"x28" hole, add gravel for drainage.

Ground Sleeve and Stop Bolt Installation

Install stop bolt, push sleeve into gravel 1" above ground level for drainage.

Concrete Mixing and Pouring

Mix concrete per manufacturer instructions and pour around the sleeve.

Curing and Final Setup

Cover sleeve with red cap, check for plumb, allow 24 hours drying, then insert flagpole.

How to Operate Your Titan Telescoping Flagpole

Attaching Harness and Flag

Prepare pole for use by attaching harness and flag snaps correctly.

Telescoping Operation

Extend sections until engaged; lower slowly to prevent damage.

How To Maintain Your Titan Telescoping Flagpole

Routine Cleaning and Care

Virtually maintenance-free; clean exterior with soap and water.

Weather-Related Precautions

Avoid lowered position in icy conditions to prevent flagpole damage from freezing.

3 Different Ways to Use Your Flag(s)

Flying Single or Multiple Flags

Attach flags to the top or second set of stainless steel clips for various display options.

Flying Flag at Half-Staff

Remove the second flag and attach the primary flag to the second set of clips for half-staff display.