Need help?Do you have a question about the Titan TTB353SHR and is the answer not in the manual?
Keep face/body from inlet; maintain balance; avoid foreign objects; shut down on unusual noise.
Shut off power and disconnect before clearing clogs or debris.
Keep guards in place; avoid feeding cable into product; keep hands/feet from cutting means.
Procedures for starting and stopping the shredder, including no-volt switch function.
Machine auto-cuts power if clogged; interlock prevents operation if hopper is not fitted correctly.
Ensure feed inlet empty; wear protection; beware of long material and snatching blades.
Prevent blockage; alternate wilted/damp waste with branches; avoid kitchen waste.
Always switch off and disconnect power before performing maintenance.
Always wear gloves when cleaning or replacing the blade.
Turn off power; align slots; use spanner/hex key; use original parts.
Blade replacement by qualified people; regrinding not recommended unless by service agent.
Power cord must be replaced by manufacturer or authorized service only.
General| Model | TTB353SHR |
|---|---|
| Shred Type | Cross Cut |
| Shred Size | 4 x 40 mm |
| Sheet Capacity | 5 sheets |
| Shred Speed | 2.5 m/min |
| Can Shred | Paper, Credit Cards |
| Auto Start/Stop | Yes |
| Overload Protection | Yes |
| Reverse Function | Yes |
| Run Time | 3 minutes |
| Cool Down Time | 30 minutes |
| Power Consumption | 220 W |
| Voltage | 220-240V |
| Frequency | 50 Hz |
To Next Page
