What to do if my Titan Nail Gun does not start?
If your Titan Nail Gun doesn't start, here's what to check: 1. Ensure it's properly connected to a power supply. 2. Make sure the product is switched ON. 3. Have a specialist electrician check the power cord or plug for defects. 4. Have a specialist electrician check for any other electrical defects.
Why is my Titan TTB516NAL Nail Gun not reaching full power?
If your Titan Nail Gun isn't reaching full power, consider these potential causes: * The extension cord may not be suitable for operation with this product; use a proper extension cord. * The power source (e.g., generator) might have too low voltage; connect to another power source. * The air vents could be blocked; clean the air vents.
How to fix fasteners that jam in my Titan TTB516NAL?
If fasteners are jamming in your Titan Nail Gun, here's what you can do: * If a nail is stuck, remove the tip of the nail sheath using the Allen wrench, then remove the cover screw tip and the cover plate. Use needle-nose pliers to clear the jammed nail, then reassemble the nail tip cover and jacket. * If the nail location is inaccurate, straight nails need to rely on the sharp end of the nail side snapping into the rail. * If the firing pin is bent, go to the after service.
Provides essential safety guidelines for operating the power tool.
General| Nail Length | 50-90 mm |
|---|---|
| Firing Mode | Sequential |
| Length | 270 mm |
| Width | 95 mm |
| Height | 280 mm |
To Next Page
