If the tool is provided for the connection of dust extraction and collecting equipment, ensure
skid footwear is
Do not expose power tools to rain. Do not use power tools in damp or wet location. Keep
TTB541DBT
Safety warnnings
WARNING! Read all instructions. Failure to follow all instructions listed below may result in
electric shock, fire and/or serious injury.
SAVE THESE INSTRUCTIONS
1. Keep the work area clean.
Cluttered areas and benches invite injuries.
2. Consider work area environment.
the work area well lit. Do
not use tools in the presence of flammable
liquids
or gases.
3. Guard against electric shock.
Avoid users body contact with earthed or grounded surfaces (e.g. pipes, radiators,
ranges,
refrigerators).
4. Keep persons away.
Do not let persons, especially children, not involved in the work touch the tool or the
extension cord and keep them
away from the work area.
5. Store idle tools.
When not in use, tools should be stored in a dry, locked up place, out of reach of
children.
6. Do not force the tool.
It will do the job better and safer at the rate for which it was intended.
7. Use the right tool.
Do not force small tools to do the job of a heavy-duty tool. Do not use tools for
purposes not
intended,
for example, do
not use circular saws to cut tree limbs or logs.
8. Dress properly.
Do not wear loose clothing or jewellery, they can be caught in moving parts. Non-
rcommended when working outdoors. Wear protective hair covering
to contain long hair.
9. Use protective equipment.
Use safety glasses. Use face or dust mask if working operations create dust.
10. Connect dust extraction equipment.
these are connected and properly used.
11. Do not abuse the cord.
Never yank the tool to disconnect it from the socket. Keep the cord away from heat,
oil and
sharp edges.
12. Secure work.
Where possible use clamps or a vice to hold the work. It is safer than using your
hand.
13. Do not overreach.
Keep proper footing and balance at all times.
06
14. Maintain tool with care.
Keep cutting tools sharp and clean for better and safer performance. Follow Instructi
ons for
lubrication and
changing
accessories. Inspect tool cord periodically and if damaged have them
replaced by an authorised
service facility. Inspect
extension cords
periodically and replace if damaged. Keep handles dry, clean and free of oil or grease.
15. Disconnect tools.
When not in use, before servicing and when changing accessories such as blades,
bits
and cutters, disconnect tools
from the power supply.
To Next Page
Loading...
