What to do if no steam comes out of my Titan TTB767STM?
If no steam is coming out of the nozzle on your Titan Steam Cleaner's steam gun, there are a couple of potential causes. First, check if there is water in the water tank and refill it if necessary. Second, the appliance may not have reached the correct working temperature. Wait until the steam ready light turns green before attempting to use it.
Why are surfaces cloudy after using Titan Steam Cleaner?
If surfaces become cloudy, streaky, or spotty after using your Titan Steam Cleaner, it could be due to several reasons. First, the floor cloth or brush cover might be too wet or dirty. Disconnect it and replace it with a dry, clean one. Second, you might be directing the steam gun at one spot for too long; avoid focusing on one area for more than 15 seconds. Finally, using hard water can also cause this issue. Switch to distilled water to resolve the problem.
How to fix a hard to move floor head on a Titan TTB767STM?
If the floor head on your Titan Steam Cleaner is hard to move, it could be because the floor cloth or brush cover is not attached correctly; disconnect and refit it. Alternatively, the floor cloth or brush cover might be too wet or dirty; in this case, disconnect it and replace it with a dry, clean one.
General| Model | TTB767STM |
|---|---|
| Category | Steam Cleaner |
| Power | 1500 W |
| Steam Pressure | 3.5 bar |
| Cord Length | 5 m |
| Steam Flow Rate | 30 g/min |
| Accessories | measuring cup |
To Next Page