33
Cutting
1. Do not overwork the cutting wheel by applying too much load on the product.
2. Hold the product so that the cutting wheel is at a 90° angle to the workpiece
(Fig. 20).
3. Ensure that the wheel is kept aligned with the cut, twisting the product may
cause the wheel to shatter.
4. Work with moderate feed, suited to the material being worked.
5. Always work in an up-grinding motion to avoid the wheel being pushed
uncontrolled out of the cut.
6. Steadily guide the product in the direction of arrow to complete the cutting
action (Fig. 21).
Fig. 20 Fig. 21
WARNING! Do not brake the wheel by applying sideward pressure.
After use
1. Switch the product off, disconnect it from the power supply and let it cool
down.
2. Check, clean and store the product as described below.
90°
TTB879GRD by TITAN
To Next Page
Loading...
