35
Maintenance
Before and after each use, check the product and accessories (or attachments)
for wear and damage. If required, exchange them for new ones as described in
this instruction manual. Observe the technical requirements.
Power cord
If the supply cord is damaged, it must be replaced by a specially prepared cord
available through the service organization.
UK plug (for UK only)
If you need to replace the fitted plug, then follow the instructions below.
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Blue – Neutral
Brown – Live
As the colours of the wire in the mains lead of this product may not correspond
with the coloured marking identifying the terminals in your plug, proceed as
follows. The wire, which is coloured blue, must be connected to the terminal,
which is marked with N or coloured black. The wire, which is coloured brown,
must be connected to the terminal, which is marked L or coloured red.
Connect Blue to N
(Neutral)
13 AMP fuse approved
to BS 1362
Outer sleeve firmly
clamped
Brown L (Live)
Cable grip
WARNING! Never connect live or neutral wires to the earth terminal of
the plug, which is marked with E.
Only fit an approved 13 Amp BS 1363 or BS 1363/A plug and correctly rated 13A
BS 1362 fuse. If in doubt, consult a qualified electrician.
TTB879GRD by TITAN
To Next Page
Loading...
