EN
TTI855PRW by TITAN
Getting started...
Before you start
23
NOTE:
entering the pump.
2.
blocked by debris at the bottom of the water source.
7
9a
9b
9
Fig. 7
The air in the water hose should be pushed through and replaced with the water
drawn in from the water source.
1.
level (<1.5m/5ft) and set the 5-in-1 nozzle (1b) at the 0+ or position to
accelerate the self-priming process. This could take up to 30 seconds or more
depending on the fresh water source.
2. Press the safety lock button (4) and then press the on/off switch (5) to switch
continually without lots of bubbles. Do not direct the water jet onto people,
animals, electrical equipment or onto the product itself.
3. In case of no water stream sprayed out within 60 seconds, inspect all
connections and the water source.
4. Release the on/off switch (5) to switch the product off. The product is now
ready for use under self-priming mode.
With water hose (connect to water tap)
WARNING! This product is not intended to be connected to the potable
Observe the regulations of your local utility company when connecting
1.
MNL_TIT_GB_18 V Handheld pressure washer_GB_V1_211101.indd 23 11/1/21 2:52 PM
To Next Page
Loading...
Need help?
General
