EN
28
EN
In
detail...
TTI855PRW by TITAN
Operation
1. Prepare the water supply as described and attach the battery pack.
2. Set the 5-in-1 nozzle (1b) to the required spray pattern.
3. Set the handle to the required positon.
4. Hold the spray gun (2) with both hands.
Fig. 11
5. Direct the water jet to the object to be cleaned and switch on the product
(Fig. 11).
WARNING!
NOTE: Always keep a reasonable distance between the nozzle and
the object to be cleaned in order to avoid damage. Ask your specialist
dealer for advice if required.
6. Release the on/off switch to stop the water jet.
Tips
WARNING! Prevent water from penetrating the air vents of the product
to minimise the risk of damage to the product.
1.
still dry. Allow the detergent to rest on the surface for a few minutes, but do
not let the detergent dry.
2. When dealing with vertical surfaces work from the bottom upwards. Rinse
from the bottom upward, use the high pressure jet at a minimum distance of
30 cm at 45° angle and then from the top downward.
3. In some cases, scrubbing with brushes is needed to remove dirt. High
pressure is not always the best solution for good washing results, since it
may damage some surfaces. The highest nozzle jet setting should not be
used on delicate or painted parts, or on pressurised components (e. g. tyres,
Operation
MNL_TIT_GB_18 V Handheld pressure washer_GB_V1_211101.indd 28 11/1/21 2:52 PM
To Next Page
Loading...
Need help?
General
