To Next PageTo Next Page
Need help?Do you have a question about the Titan VS-32-L and is the answer not in the manual?
General| Category | Industrial Equipment |
|---|---|
| Model | VS-32-L |
| Power Source | Electric |
| Motor Power | 3 HP |
| Voltage | 220-240 V |
| Frequency | 60 Hz |
Describes manual and automatic operational modes.
Technical specifications for the welding unit.
Calculation of time required for a strapping operation.
Minimum support dimensions for various packing items.
Mechanical measurements and installation dimensions.
Schematic of the pneumatic control system.
Visual representation of the operational sequence and timing.
Identification of key assembly units within the strapping head.
Lists and defines actuating magnets and control elements.
Details and functions of various switches.
Shows the physical location of components.
Step-by-step explanation of the strapping process.
Explains the different positions of the cam gear.
Details the TIG welding method and parameters.
Instructions for setting specific switches.
Procedure for setting the zero position of the welding station.
How to set clamping and opening positions.
How to adjust air pressure using pressure controllers.
Procedure for setting the welding gas quantity.
How to set the distance between electrodes.
Procedure for setting the torch.
Recommended settings for welding parameters.
General guidelines for keeping the strapping head clean and functional.
Table outlining daily, weekly, monthly, and 6-monthly maintenance jobs.
How to check the quality of the weld seal.
Identifies lubrication points and recommended lubricants.
Maintenance procedures for the transport unit wheels and guides.
Maintenance for the clamp guide and cutting edges.
Procedures for checking and maintaining the cutter.
Steps for dismounting and replacing the electrode.
Instructions for removing and installing the clamp.
Procedures for removing and fitting the torch holder.
