C-5000 Owner’s Manual
OwnC-C-3000 Manual
3
All pertinent state, regional, and local safety regulations must be observed when
installing and using this product. For reasons of safety and to help ensure compliance
with documented system data, only the manufacturer shall perform repairs to
components.
When devices are used for applications with technical safety requirements, the relevant
instructions must be followed.
Failure to observe this information can result in injury or equipment damage.
Titronics R & D has made every effort to prevent that the labelling, instructions for use,
making available, putting into service and advertising of devices uses text, names,
trademarks, pictures and figurative or other signs that may mislead the user or the patient
with regard to the device's intended purpose, safety and performance.
Copyright © 2019 by Titronics R & D
All rights reserved. No part of this publication may be reproduced, distributed, or
transmitted in any form or by any means, including photocopying, recording, or other
electronic or mechanical methods, without the prior written permission of the publisher.
For permission requests, write to the publisher, addressed “Attention: Permissions
Coordinator,” at the address below.
Titronics R & D , 400 Stephans Street Unit D, Tiffin, Iowa 52340 phone 319 545
7377 www.titronics.com
TRADEMARKS
Titronics R & D has made every effort to supply trademark information about company
names, products and services mentioned in this manual. Trademarks shown below were
derived from various sources. All trademarks are the property of their respective owners.
General Notice: Some product names used in this manual are used for identification
purposes only and may be trademarks of their respective companies.
Product Modifications
Document Revisions
An ergonomic handle was added / serial interface added
PIC processor – true RS-232 Serial Communication
2007 C-5000
FTDI Serial – USB IC added for USB direct interface
and power, odometer wheel brackets upgraded to
machined aluminum, fiber optic wheel target distance
odometer replaced with miniature LED/Sensor IC in
2012 C-5000 – 3 volt
The scanner “head” and computer board parts were
updated to operate on a 3.3 volt power supply.
To Next Page