TKMOUNTS Skull Mount Clamp
Thank you for your purchase! We are happy to help you preserve the memory of your hunt.
Tools required:
Electronic stud finder for drywall installation
Phillips head screw driver
Enclosed wrench
Electric drill, wood or masonry drill bit, depending on mounting surface
Pencil
Optional: level
Installation diagram: (Enclosed – 1 fully assembled skull clamp, 1 wrench, 2 wall screws)
Installation instructions:
Prior to installation of this product, the installation instructions and CAUTIONS should be read and completely
understood. The installation instructions and CAUTIONS must be read to prevent personal injury and property
damage. Keep these installation instruction in an easily accessible location for future reference.
1. Adjust the three rotation joints to the ideal tension. Using the wrench provided, adjust all three joint nuts on
the mounting device so the joints can be rotated by hand, but have enough tension to hold in place. The joints
should not be loose, but should be able to rotate with force applied by hand– DO NOT OVER-TIGHTEN THE JOINT
NUTS. Turn the three joints so there is clear access to the screw openings of the wall plate.
2. Mount wall plate to the wall. Locate a stud in the wall you wish to hang your mount. Pre-drill a pilot hole in the
stud at the desired height, or directly in the wall if it is cement or brick. Hold the device to the wall, so the hole
drilled in the wall is centered in the top opening of the mounting plate. A level may be used to ensure the plate
is vertical. Using a pencil through the lower opening of the wall plate, mark the 2
nd
hole to be drilled in the wall.
Set the mount aside and drill your 2
nd
pilot hole. Hold the wall plate to the wall so that the two pilot holes are
centered in its openings. Use a screwdriver to mount the plate to the wall stud using the two screws.
functioning of the TKMOUNTS Skull Mount Clamp is
dependent on the joint nuts being loose enough to move with applied force,
but tight enough to hold in place against gravity and incidental force.
black scratch-resistant finish. The finish is,
however, not scratch-proof. Take care during install
and adjustment to minimize contact between tools
and surfaces not being adjusted.
To Next Page
Need help?
General