TKSTAR GTSTAR - Shake Alarm Setting and Canceling; Device Working Mode Setting; Terminal Time Setting

minutes.
Over-speed Alarm canceling ：
Command ：nospeed123456
Reply：nospeed ok
4.4. Shake Alarm setting
Command：shock123456
Message Reply：shock ok
E.g：
Note:Pls keep the tracker being stationary for 5 minutes, this function will work.
The tracker will send SMS “sensor alarm!” to the admin number when the unit get shocked.
Shake alarm Canceling:
Command：noshock123456
Reply：noshock ok
4.5. Device working mode setting
Sleep by time mode setting：
Command：sleep123456 time
Reply：sleep time ok
E.g：
(Tracker only works for 5 minutes after being waked up, and back to sleep mode, GPS shut off, GSM
works in low consumption mode. SMS command, calling tracker can wake up the tracker.)
Sleep by shock sensor mode setting: (Factory setting is “Sleep by shock mode“)
Command：sleep123456 shock
Reply：sleep shock ok
E.g：
(No shock for 5 minutes, the tracker will work in “sleep by shock” mode, GPS shut off, GSM works in low
consumption. Vibration, SMS, calling can wake up the tracker.)
4.6 Terminal (local) Time Setting(factory setting GMT 0)
Command：timezone123456 local time zone