To Next PageTo Next Page
Need help?Do you have a question about the TL Audio FATMAN FAT 1 and is the answer not in the manual?
General| Brand | TL Audio |
|---|---|
| Model | FATMAN FAT 1 |
| Category | Recording Equipment |
| Language | English |
Details on connecting the FAT 1 to the AC mains supply using the provided IEC connector and plug.
Instructions for connecting balanced and unbalanced line inputs via TRS jack sockets.
Guide for connecting instruments using the front panel 0.25-inch jack sockets.
Information on connecting balanced or unbalanced outputs via TRS jack sockets.
Guidance on setting the rear panel switch for +4dBu or -10dBu operating levels.
Important notes on ensuring adequate airflow and heat dissipation for the unit.
Explains manual and preset modes, threshold, and ratio controls for signal compression.
Adjusting signal level to the input stage, affecting valve drive and compression.
Controlling the final output signal level of the FAT 1.
Restoring signal level lost during compression, active when compressor is on.
Selecting 16 factory preset compression settings or manual mode.
Setting the signal level above which gain reduction begins.
Determining the amount of gain reduction applied above the threshold.
Configuring how quickly the compressor reacts to and recovers from signals.
Selecting between soft or hard knee compression curves for varying effects.
Guide to connecting the compressor as an instrument front end or to mixer insert points.
Step-by-step instructions for setting up and adjusting the compressor's parameters.
Answers to common queries regarding the FAT 1's stereo operation and controls.
