Rear panel selectable for 220-240V 50Hz or 110-120V 60Hz
operation.
Rear panel fuse 20mm, 1AT, 250V.
Power consumption 30VA typical.
Detachable 3 pin IEC connector, mating connector and cable supplied.
Front panel On/Off switch with green LED.
Dimensions:
19” rack mounting, 1U high.
483mm wide x 44mm high x 250mm deep.
Weight: 4Kg.
The above specifications are subject to change without notice.
SERVICE
Should the compressor require service, it must be taken or posted to an authorised dealer. Please retain the
original packing for possible future use, and ensure the unit is suitably protected during transit. The
manufacturer cannot accept responsibility for damage caused during transportation.
The compressor is supported by a limited warranty for a period of one year from the date of purchase.
During this period, any faults due to defective materials or workmanship will be repaired free of charge.
The warranty excludes damage caused by deliberate or accidental misuse, operation on the incorrect mains
voltage, or without the correct type and value of fuse fitted. It is the user’s responsibility to ensure fitness for
purpose in any particular application. The warranty is limited to the original purchase price of the equipment,
and excludes any consequential damage or loss.
Please retain proof of purchase, and record the following details:
Serial Number.............................
To Next Page
Loading...