Injection Molding Machine Chapter 4
V3.0
4-60
5.4 Start molding
Upon completion of sections 5.1
，
5.2
，
5.3
，
preparations shall be made for before production
，
usually
semi-auto operation shall be confirmed before change to auto operation..
CAUTION
Please confirm once again that sufficient plastic material has been available in the
hopper and material type is correct.
5.5 Material or color change
Upon material or color change
，
the automatic purge function provides the convenience for easy
operation.
Ａ
After setting each timer (recommended values shown in table below)
，
retract carriage to proper
position.
Ｂ
Press F3 barrel purge function to start this function.
CAUTION
Please confirm once again that sufficient plastic material has been available in the
hopper and material type is correct.
CAUTION
Please confirm that operation mode is manual
，
otherwise
，
no actuation can be
made.
Item Suck back
time
Charge
time
Delay time Injection time Interval time Number of cycles
Recommended
value (sec)
2.0-5.0 5.0 5.0-10.0 2.0-7.0 5.0-10.0 1.0-2.0
5.6 Save/Load molding data from memory card
Upon completion of mold change or mold testing run
，
please save the molding conditions in the
memory card immediately
，
for operation procedures
，
please refer to page 4-32 of chapter 4.
To Next Page
Loading...